Will not print fully,what I see on screen. Only half the WIDTH of screen . I

[blotter]

Will not print what I see on P C . screen Only half the WIDTH of screen shot ..I strongly suspect this is not a printer problem  

Hope your Guys can help Thanks Brian  18/01/2019

[The_Fossette]

@blotter,

Welcome to the HP Support Community!

I assure you I will try my best to get this sorted.

In order that I may provide you with an accurate solution, I will need a few more details.

• When was the last time the printer was working fine?
• Are you facing the same issue when you make a copy?
• From which application/software you are printing?
• Have you made any software or hardware changes on the computer?
• Have you performed any troubleshooting steps before posting?

While you respond to that, I recommend follow the below steps and check if it helps.

1.With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.

2.Remove USB cable, if present.

3.Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.

4.Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.

5.Turn on the printer and wait till warm-up period finishes and the printer is idle.

If you continue facing the issue, I recommend you perform a run uninstall and then reinstall the printer.

Here is how it is done.

1.) In Windows, search for and open Programs and features

2.) Select your HP Printer

3.) Select Uninstall

4.) In Windows, search for and open Devices and printers

5.) In the Devices and Printers windows look for your HP printer. If you see it listed right-click on it and choose ‘Delete’ or ‘Remove Device’

6.) Open up the run command with the “Windows key + R” key combo.

7.) Type printui.exe /s and click Ok. (Note: there is a space in between “printui.exe” and “/s”)

8.) Click on the “Drivers” tab

9.) Look for HP Printer driver. If you see it Click on it and click Remove at the bottom

10.) Select Ok

11.) Select Apply and Ok on the Print Server Properties windows

12.) Close Devices and Printers

13.) Restart the PC

14.) Download and install the printer software from the below link.

http://hp.care/2nikIQ9

15.) Connect the USB cable ONLY when prompted and follow the on-screen instructions.

Let me know how it goes and you have a great day!

If you wish to show appreciation for my efforts, mark my post as Accept as Solution. Your feedback counts!

Cheers!