cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
  • ×
    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
Highlighted
New member
1 0 0 0
Message 1 of 2
513
Flag Post

constant orange light and flashing envelope symbol on display screen

HP Recommended
HP Deskjet 3636
Microsoft Windows 10 (64-bit)

Hi all

I have a constant orange light next to the 'i' symbol on the printer, and a flashing envelope and tear drop symbol on the display screen on the printer.

I have done all the usual tricke, turning off and on, purging, even put in new cartridge.

|Still no joy

1 REPLY 1
Highlighted
HP Support Agent
HP Support Agent
12,711 12,688 1,002 967
Message 2 of 2
Flag Post
HP Recommended

@RussG7990, Welcome to HP Support Community!

 

Step 1: Perform a hard reset on the printer-

  1. Turn the printer on, if it is not already on.
  2. Wait until the printer is idle and silent before you continue.
  3. With the printer turned on, disconnect the power cord from the rear of the printer.
  4. Unplug the power cord from the wall outlet.
  5. Wait at least 60 seconds.
  6. Plug the power cord back into the wall outlet.
  7. Reconnect the power cord to the rear of the printer.
  8. Turn on the printer, if it does not automatically turn on.
  9. Wait until the printer is idle and silent before you proceed.

Step 2: Check the input/output tray

Load the printer with plain, white paper.

  1. Raise the input tray.

    Figure: Raise the input tray

    Image: Pull up the input tray
  2. Slide the paper width guide all the way to the left.

    Figure: Slide the paper width guide left

    Image: Slide the paper width guide left
  3. Load plain white paper into the input tray, and then slide the stack of paper down until it stops.

    Figure: Load plain white paper

    Image: Load plain white paper
  4. Slide the paper width guide to the right until it stops at the edge of the paper.

    Figure: Slide the paper width guide right

    Image: Slide the paper width guide right
  5. Pull out the output tray, and then raise the tray extender.

    Figure: Pull out the output tray, and then raise the tray extender

    Image: Pull out the output tray and tray extender

Try printing and see if it helps.

 

If the issue persists, try updating the printer firmware.

Refer to this document for help

 

Let me know the outcome.

Cheers 🙂

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

TEJ1602
I am an HP Employee

0 Kudos
Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation