cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New member
1 0 0 0
Message 1 of 2
86
Flag Post
HP Recommended

officejet pro 8610 print issue

officejet pro 8610
Microsoft Windows 10 (64-bit)

Hey. I have printed some normal pieces of papers. but suddenly one piece of paper got stock inside the printer. I turned off the printer and pulled the paper out, when i turned on the printer it is writing "Printerfejl" translated it is "Print failure" 

The description is like this (there is a problem with your printer or inksystem, please turn off and turn on the printer. Contact HP Support if the problem continues)

I push the questionmark on the display and get following text (Solution 1: reset the product. Turn off and pull the cable out, insert the cable again and push the power button to turn on the product again. Solution 2: Contact HP Support. Write down the failure code and contact the support. Go to www.hp.com/support

 

I have tried follow these steps, and it does'nt work. I have also tried to use the doctor software. nothing works. the last problem is that there is not any failure code in the massage for me to give the support. 

 

I hope somebody can help me out of this problem

1 REPLY 1
Highlighted
HP Support Agent
HP Support Agent
19,343 19,246 1,099 1,186
Message 2 of 2
51
Flag Post
HP Recommended

officejet pro 8610 print issue

@Renehh87

 

Welcome to HP support community.

 

Remove and reinsert the ink cartridges

  1. Open the door to access to the ink cartridges.

  2. Wait until the carriage stops moving before you continue.

  3. Push the ink cartridge to remove it, and then push it into its slot until it snaps into place.

    Animation of replacing the ink cartridges

  4. Repeat these steps for the other three ink cartridges.

  5. Close the ink cartridge access door.

Check the carriage for a printhead latch

Open the door to access to the ink cartridges, and then determine if the carriage inside the printer has a printhead latch.

Example of a carriage with a latch on the printhead

Image of carriage with a printhead latch

 

You can refer this HP document for more assistance:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

0 Kudos
Be alert for scammers posting fake support phone numbers on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation