cancel
Showing results for 
Search instead for 
Did you mean: 
jcmcwill
New member
1 0 0 0
Message 1 of 2
98
Flag Post
HP Recommended

Rear door will not close on LaserJet Pro M452dn

LaserJet Pro M452dn

Hello all:

I had a major paper jam the required me to take out the fuser to remove the jam.  After reassembling the printer, the rear door will not close.  The left side of the door closes but the right side of the door does not.  It seems that there is a black piece of plastic about halfway down that is in the way, thus preventing the door to fully close.  I fully reversed all the steps of removing fuser and reassembling the printer but still the same problem.  I was very careful to not break or force anything with disassemble/reassemble of the printer, but am completely stumped with this problem.  any ideas?

1 REPLY 1
Level 11
Level 11
3,524 3,510 346 732
Message 2 of 2
78
Flag Post
HP Recommended

Rear door will not close on LaserJet Pro M452dn

Post some pictures of what you are seeing to make this easier to help you with.

If you find the information provided useful or solves your problems, help other users find the solution easier by giving kudos and marking my post as an accepted solution.
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation