clear error in printer

[RossBrayne]

My printer jammed a sheet of paper. It ripped a corner off on it's way from feed tray.

Both parts of the paper have been removed.

The error light is still flashing.

How do I clear this?

[KrazyToad]

@RossBrayne

I have gone through your Post and I would like to help

Please perform a printer reset

- With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
- Wait at least 60 seconds.
- Plug the power cord back into the wall outlet.
NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
- Reconnect the power cord to the rear of the printer.
- Turn on the printer, if it does not automatically turn on.
- The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
- Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
 

Also ensure the Firmware is up to date. You can refer to this Link: https://support.hp.com/in-en/document/c02919168

If the issue persists please follow the instructions in this Link: https://support.hp.com/in-en/document/c03921935 to help check for paper jams

Keep me posted 😊

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.