cooling down mode

[bimmerguymx]

im tired of this issue, its just ridiculous, 

every single time i try to printout immediately goes to "cooling-down mode" i did a firmware update the same thing, last time i printout the setup reports and the demo page, works fine for 10 pages, after that i can not print anything

[ALS-77]

I suspect the fuser is not working correctly. I would replace the fuser. It's possible the low voltage power supply could be bad, but I've seen the fuser cause this more than anything else.

[bimmerguymx]

i also was thinking about that, but i could not find some instructions to remove it, do you have some instructions or video about replacing the fuser?

thanks

[ALS-77]

I'm sending you a private message with a link to a site where you can download the manuals for your printer.