cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New member
1 0 0 0
Message 1 of 3
100
Flag Post
HP Recommended

initialization looping

Microsoft Windows 10 (64-bit)

Hello, i need . I have  a hp M1212nf, the printer is locked in a initialisation loop after update the firmware. 

2 REPLIES 2
Highlighted
Level 11
Level 11
3,292 3,286 379 477
Message 2 of 3
75
Flag Post
HP Recommended

initialization looping

Remove side cover disconnect fax modem and check will printer initialize without a fax modem.


#stayathome#ostanimodoma

View my profile on LinkedIn
Reply
0 Kudos
Highlighted
Level 6
318 318 30 47
Message 3 of 3
56
Flag Post
HP Recommended

initialization looping

A safe option to always try is a Power Reset to eliminate a possible logic issue:
First, make sure the printer is plugged straight into a wall outlet and not a power strip, surge protector or UPS.
With the printer plugged in and powered ON, disconnect the power cord from the printer. This will hopefully dissipate any electricity stored in the printer that could be hindering it.
Wait at least 30, preferably 60 seconds.
If there is a power switch, turn it to the OFF position.
Plug the power cable back into the printer.
Turn the printer ON with the power switch.

Reply
0 Kudos
Be alert for scammers posting fake support phone numbers on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation