Post new question
Posts: 1
Member Since: ‎05-28-2009
Message 1 of 4 (59,392 Views)

laserjet 4015 reset maintenance

I changed the maintenance kit on a laserjet 4015. I followed the instructions on how to reset the maintenace count: press and hold the OK button when xxx MB is displayed and then release when all three lights are lit up. The instructions then say to press the up arrow until reset maintenace count is displayed. I press the up arrow, but there is no option to reset the maintenance count. The only options listed are: select language, self test, cold reset, and embedded LAN disable. Any ideas? thanks.
0 Kudos
Honor Student
Posts: 2
Member Since: ‎06-23-2009
Message 2 of 4 (59,233 Views)

Re: laserjet 4015 reset maintenance

Hi ... I gess there is another reset menu listed in the printer ... try to find it and use it to clear the reset maintenence message ... 
Posts: 1
Member Since: ‎01-20-2010
Message 3 of 4 (57,997 Views)

Re: laserjet 4015 reset maintenance

I found this online-


Some of the older firmware versions did not have the "New Maintenance Kit" option mentioned in the above procedure. In this case you can either update the printer's firmware to ad this feature or manually reset the maintenance count in the service menu as described below.

Enter the Service Menu -- Press the MENU button, and scroll through the list of menus until you see "SERVICE". Press OK.

Before you can enter the Service Menu, you will see a blank line on the screen where you are supposed to enter an access code:

On a LaserJet P4014, the access code is 05401408

On a LaserJet P4015, the access code is 05401508

On a LaserJet P4515, the access code is 05451508

Enter the code and press OK.

You will now be allowed into the Service Menu. Scroll through the list of options until you see, "Maintenance Count." Press OK.

Change the current maintenance count to "0" by pressing the number "0", and then pressing OK.

To confirm this, you can print an Information page.

Posts: 16
Member Since: ‎04-15-2014
Message 4 of 4 (6,040 Views)

Re: laserjet 4015 reset maintenance

[ Edited ]

Hello, we replaced the maintenance kit on Tuesday, 20 September, and I installed the new firmware on Wednesday.  The maintenance kit still shows that it needs to be replaced at 3 percent life left.  How does this get reset?  I need to do it through the web interface since the printer is in a remote location.  I installed the new firmware remotely.  Thank you.


† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation