• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We are proud to announce new Poly Studio Series video bars and remote room control with Poly Connect. Read more about the solutions!
Locked

‎11-03-2016 11:32 AM

HP Recommended

Good afternoon,

 

Recently upgraded 4 Polycom Group 500 series endpoints to version 6.0.0-280932. Since that time, any time we do a point to point from one of these 4 endpoints, one of the locations does not receive any audio or video, but the other side receives audio / video without any issues. 

 

If two of these same endpoints dial into the a 5310 MCU , video / audio for BOTH sites pass through without any issue. Looking at the CDRs I noticed that for point to point, H.264-HP (high profile) is used, but when the systems go through the MCU, just H.264 is being used. 

 

Could High Profile be the issue and how do I disable it? Bandwidth is not a concern for us. 

1 ACCEPTED SOLUTION

Accepted Solutions

‎11-04-2016 10:27 AM

HP Recommended

If this was working prior to upgrading to 6.0 please open a service report with your Polycom service site so that Polycom engineering can look at this.

 

If you can get Wireshark traces along with the endpoint logs that may help them.

 

 

View solution in original post

Was this reply helpful? Yes No
1 REPLY 1

‎11-04-2016 10:27 AM

HP Recommended

If this was working prior to upgrading to 6.0 please open a service report with your Polycom service site so that Polycom engineering can look at this.

 

If you can get Wireshark traces along with the endpoint logs that may help them.

 

 

Was this reply helpful? Yes No
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.