cancel
Showing results for 
Search instead for 
Did you mean: 
JaccBalle
New member
3 1 0 0
Message 1 of 5
126
Flag Post

Can not connect to new router

HP Recommended
DeskJet 2622

Hello. Recently got a new router so I need to connect printer. I do not know my printer IP address. Can I do a factory reset on my printer so I can start from

scratch?

Tags (1)
4 REPLIES 4
ShlomiL
Level 17
Level 17
31,430 31,141 5,369 12,506
Message 2 of 5
Flag Post
HP Recommended

Hi,

Please follow 'Connect a printer that does not have a touchscreen control panel >> Step 2: Connect the printer with the HP Smart app' below to reset the wireless settings and then reconfigure the wireless connection for your new router:

https://support.hp.com/us-en/document/c05987925

 

Shlomi



Say thanks by clicking the Kudos thumb up in the post.
If my post resolve your problem please mark it as an Accepted Solution 🙂
0 Kudos
JaccBalle
Author
New member
3 1 0 0
Message 3 of 5
Flag Post
HP Recommended

Thank you but your suggestion will not work. Printer does not come up in app. Reset router and printer. Printer shows in my wifi on phone but can not connect. I would like to delete and start over!

0 Kudos
ShlomiL
Level 17
Level 17
31,430 31,141 5,369 12,506
Message 4 of 5
Flag Post
HP Recommended

Hi,

Can you see an HP-Setup network within the nearby wireless networks?

 

What router do you have? The printer only supports a 2.4GHz wireless and there are dual-band routers today, ensure you are connected to the 2.4GHz wifi network, and that your router have a unique SSID for each wireless band.



Say thanks by clicking the Kudos thumb up in the post.
If my post resolve your problem please mark it as an Accepted Solution 🙂
0 Kudos
banhien
Level 19
Level 19
90,935 90,812 11,698 25,055
Message 5 of 5
Flag Post
HP Recommended

@JaccBalle 

 

I saw your other post. Please use the following instructions to fix:


               http://www8.hp.com/au/en/campaigns/wireless-printing-center/reconfiguring-system-help3.html


Please also note: Your printer only supports 2.4GHz therefore you need to check and allow your router to broadcast both (dual) bands which are 2.4GHz and 5.0GHz.


Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.



0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation