Error 0x61000072 from printer

[jacedagrace23]

When i decide to print the printe rmakes avery large noise as if the cartridges are stcuk. It almost sounds like if the printer were pretending to be a gun. I have tried using the HP print and scan doctor however, it cannot connect with the printer wirelessly (I do not have the cable to connect them). I also do have genuine HP cartridges installed. Thank you in advance.

[KrazyToad]

@jacedagrace23

I have gone through your Post and I understand your concerns

- Turn on the printer.
- Wait until the printer is idle and silent before you continue.
- Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
- Remove the ink cartridges from the printer.
- With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
- Wait at least 60 seconds.
- Plug the power cord back into the wall outlet.
NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
- Reconnect the power cord to the rear of the printer.
- Turn on the printer, if it does not automatically turn on.
- The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
- Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
- Reinsert the ink cartridges, and then close the ink cartridge access door.
- If you receive a prompt to print a calibration page, do so.
 

Also ensure the printer has the latest Firmware. Link: https://support.hp.com/in-en/document/c02919168

Keep me posted  😊 

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.