cancel
Showing results for 
Search instead for 
Did you mean: 
Abraham13
New member
1 0 0 0
Message 1 of 2
512
Flag Post

Hp envy photo 7855 gives blurred and photos with orange/red tint across

HP Recommended
Hp Envy photo 7855
Android 9.0 Pie

I set up a new printer and when i printed a photo its comes with a orange/red tint, blurred and not aligned as in the original picture.

What could be causing this? appreciate any help.

1 REPLY 1
sandytechy20
HP Support Agent
HP Support Agent
26,807 26,680 1,466 1,538
Message 2 of 2
Flag Post
HP Recommended

@Abraham13

 

Welcome to HP support community.

 

Did you make a copy and check if that prints fine?

 

Meanwhile:

Print a Print Quality Diagnostic page

  1. On the control panel, swipe down to open the Dashboard, and then touch the Setupicon.

  2. Swipe up on the display, touch Reports, and then touch Print Quality Report.

    A Print Quality Diagnostic page prints.

    Print Quality Diagnostic report without defects

If that does not print fine, follow the below steps:

Manually clean the area around the ink nozzles

  1. Gather the following materials:

    • A clean, lint-free cloth or a clean, dry cotton swab

    • Distilled or bottled water

         CAUTION: 

      Do not use tap water because it might contain contaminants that can damage the printhead.

  2. Open the ink cartridge access door.

    Open the ink cartridge access door

  3. Wait until the printer is idle and silent before you continue.

  4. Lightly press down on the ink cartridge to release it, and then pull the ink cartridge out of its slot.

    Pressing down to remove the ink cartridge

       CAUTION: 

    Do not remove both ink cartridges at the same time. Remove and then clean each ink cartridge one at a time. Do not leave an ink cartridge outside the printer for more than 30 minutes.

  5. Hold the ink cartridge by its sides.

    Holding the ink cartridge by its sides

  6. Lightly dampen a clean, lint-free cloth or swab with bottled or distilled water.

  7. Clean the face and edges around the ink nozzle with the cloth or swab.

       CAUTION: 

    Do not clean the ink nozzle plate.

    Cleaning the area around the ink nozzle

    1. Nozzle plate - Do not clean

    2. Area surrounding ink nozzle - Do clean

    3. Ink cartridge contacts - Do not clean

  8. Wait 10 minutes for the cleaned area to dry before you continue.

  9. Hold the ink cartridge by its sides with the contacts toward the printer, insert the ink cartridge into its slot, and then gently push the ink cartridge until it snaps into place.

    Snapping the ink  cartridge into place

  10. Repeat these steps to clean around the nozzles on the other ink cartridge.

  11. Close the ink cartridge access door.

You cab refer this HP document for more assistance:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation