Poor print quality, how to fix via mobile app as I have no PC

[Courts021]

The print quality is very poor but both ink cartridges are full.

I only have the mobile app, no PC so unsure how to fix it from the app?

[sandytechy20]

@Courts021

Welcome to HP support community.

Manually clean the area around the ink nozzles

1. Gather the following materials:

   • Dry foam-rubber swabs, lint-free cloth, or any soft material that does not come apart or leave fibers (coffee filters work well)

   • Distilled, filtered, or bottled water (tap water might contain contaminants that can damage the ink cartridges)

        CAUTION: 

     Do not use platen cleaners or alcohol to clean the ink cartridge contacts. These can damage the ink cartridge or the printer.

2. Press the Power button to turn on the printer, if it is not already on.

3. Open the exterior door, and then grasp the handle and lower the ink cartridge access door to open it.

   The carriage moves to the center of the printer.

   Figure : Open the ink cartridge access door

   

4. Wait until the carriage is idle and silent before you continue.

5. Lightly press down on one of the ink cartridges to release it, and then pull the ink cartridge toward you out of its slot.

   Figure : Press down to remove the ink cartridge

   

      CAUTION: 

   Do not remove both ink cartridges at the same time. Remove and clean each ink cartridge one at a time. Do not leave an ink cartridge outside the printer for more than 30 minutes.

6. Hold the ink cartridge by its sides.

   Figure : Hold the ink cartridge by its sides

   

7. Inspect the ink cartridge contacts for ink and debris buildup.

      CAUTION: 

   Do not touch the copper-colored contacts or the ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.

   Figure : Do not touch the contacts or nozzles

   

8. Lightly moisten a foam-rubber swab or lint-free cloth with distilled water, and then squeeze any excess water from it.

9. Clean the face and edges around the ink nozzle with the swab.

      CAUTION: 

   Do not clean the ink nozzle plate.

   Figure : Clean the area around the ink nozzle

10. 1. 

       Nozzle plate - Do not clean

    2. Area surrounding ink nozzle - Do clean

    3. Ink cartridge contacts - Do not clean

11. Either let the ink cartridge sit for 10 minutes to allow the cleaned area to dry, or use a new swab to dry it.

12. Slide each ink cartridge at a slight upward angle into the empty slot, and then gently push up on each ink cartridge until it locks into place.

    Figure : Push the ink cartridge into its slot

    

13. Repeat these steps to clean around the nozzles on the other ink cartridge.

14. Close the ink cartridge access door.

15. Reconnect the power cord to the rear of the printer.

16. Press the Power button to turn on the printer, if it does not turn on automatically.

You can refer this HP document to fix the issue:- Click here

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.