• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
HP Recommended
HP Probook 650 G1
Microsoft Windows 10 (64-bit)

Hi!

 

My HP Probook 650 G1 does not booted from one day to the next!

 

1) Without power supply, the notebook is literally dead. No LEDs, no sounds, just nothing..
2) The notebook can not be switched on even with the power adapter supply in. However, the power switch and 2 Leds (white + orange) in the front are constantly blinking (once per sec). I have attached a photo...

 

=> Battery out, Ram out, HDD plugs removed, hardware reset (15s power switch)... nothing helps 😞

Does anyone have an idea?

 

Thanks,
Jim

 

HP (1).jpg

10 REPLIES 10
HP Recommended
HP Recommended

Hi!

 

I made video of the blinking leds: https://streamable.com/6bute

Is that a 2.2 error?

 

Thanks

HP Recommended

Hi

A 2.2 is BIOS.

I counted 3 blinks.

LED blinks 3 times

Memory

RAM Module failure.

1 Reseat the memory. NB:- See the Services Media Library for steps for your PC.

2 Check each individual memory module and swap slots.

3 Replace the memory modules causing three blinks or if the blinks follow the slots.

4 Replace the Main-Board.

3

MEMORY READ OR WRITE FAILURE

Caps/Num lock lights = 3 blinks - Memory module error.

 

 

 

 

 

HP Recommended

Hi!

 

It's not just blinking 3 times... It blinks constantly as long as the power supply is plugged in.

Caps/Num is not blinking at all.. The notebook is from 2014

 

Thanks,

Jim

HP Recommended

Hi

Amber battery light: blinks 1 Hz continuously - Embedded Controller unable to load firmware.

 

This will not work for everyone, but you may be lucky?


HP Notebooks and Mobile Workstations -
No Power, No Boot, No Display When Power Button Is Pressed



NOTE: Be sure the battery is installed in the computer and it has sufficient power before continuing. Due to the design of the Embedded Controller/Keyboard Controller, the power supply must be disconnected and the computer must be powered with battery power to reset the Embedded Controller/Keyboard Controller.

Unplug the AC power from the computer.
Press and hold the power button for more than 12 seconds.
Release the power button (after at least 12 seconds).
The computer will power on and should boot normally after releasing the power button.
Re-connect the AC power to the computer.

NOTE: In case the battery is not charging after performing the steps to reset the Embedded Controller, unplug and re-plug in the AC power again.

 

 

HP Recommended

I tried to disconnect the mainboard battery for a short time. Unfortunately also no success ...

HP Recommended

Boot-error codes Blink codes - Error

Amber battery light: blinks 1 Hz continuously - Embedded Controller unable to load firmware.

 

 

 

HP Recommended

So you mean the mainboard is broken?

HP Recommended

Hi

No, I do not know which piece of embedded firmware is the cause.

 

""NOTE: Be sure the battery is installed in the computer and it has sufficient power before continuing. Due to the design of the Embedded Controller/Keyboard Controller, the power supply must be disconnected and the computer must be powered with battery power to reset the Embedded Controller/Keyboard Controller.""

 

I'm guessing here but you do not seem to have powered only with the battery from your replies,

"I tried to disconnect the mainboard battery for a short time. "

"It blinks constantly as long as the power supply is plugged in.

Caps/Num is not blinking at all.."

 

But if I am wrong, then you may indeed have a faulty Main-Board.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.