Post new question
Honor Student
Posts: 2
Member Since: ‎07-31-2011
Message 1 of 1 (332 Views)

Mini 311 Netbook doesn't boot; in loop

[ Edited ]

The screen flashes HP logo and lower left of screen says "Press the ESC key for start up menu" and then "Prepare boot to OS".  If you press ESC, nothing happens and screen goes blank (and the repetitive cycle of flashing HP logo and messages ceases).  The fan is on, LEDs are on, the disk drive light is flickering, etc.  Running Windows 7.  On each loop cycle, there is also a small audible click/noise on the PC's speaker at the end of the cycle (which repeats every 3-4 seconds).


I followed the instructions to remove the battery etc. and do a hard reset etc. but that didn't work.

0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation