cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
Fursang
New member
1 0 0 0
Message 1 of 2
114
Flag Post

My hp laptop stuck at press esc key for startup. Menu, help

HP Recommended
Hp pavilion notebook
Microsoft Windows 7 (32-bit)

I can only go to bios setting by pressing esc key i test hard drive it pass nothing problem and also correct date and time. 

1 REPLY 1
praveenbv
HP Support Agent
HP Support Agent
6,977 6,975 302 367
Message 2 of 2
Flag Post
HP Recommended

@Fursang, Welcome to the HP Support Community!

 

 

As I understand you need a fix for the no Boot issue,

Don't worry as I'll be glad to help, however, to provide an accurate resolution, I need a few more details: 

Do you get any blue screen errors before the device shuts down?

 

While you respond to that, here's what you need to know:

This scenario usually indicates a problem with the hardware. To help isolate the problem, check the following items:

  1. Overclocking: Disable overclocking to see whether the issue occurs when the system is run at the correct speed.
  2. Check the memory: Verify the memory by using a memory checker. Verify th
  3. at each memory chip is the same speed and that it is configured correctly in the system.
  4. Power supply: Make sure that the power supply has enough wattage to appropriately handle the installed devices. If you added memory, installed a newer processor, installed additional drives, or added external devices, such devices can require more energy than the current power supply can provide consistently.
  5. Overheating: Check whether the system is overheating by examining the internal temperature of the hardware.
  6. Defaults: Reset the system back to the system defaults to see whether the issues occur when the system is running in its default configuration. 

 

If you see that the computer generates a Stop error that contains a BugcheckCode value that is not reported in an event ID 41, change the restart behavior for the computer. To do this, follow these steps:

  1. Right-click My Computer, and then click Properties.
  2. Click Advanced system settings.
  3. Click the Advanced tab.
  4. In the Startup and Recovery section, click Settings.
  5. Click to clear the Automatically restart check box.

If you've been using the Recovery Partition (F11) to reinstall the OS, I recommend using the Recovery media instead to wipe out the HDD and create a new partition and fresh OS installation: Click here to obtain one, if you don't have on in your possession.

 

Hope this helps! Keep me posted. 

 

 

 

             

 

Hope this helps! Keep me posted. 

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!

Have a great day! 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation