cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
RudRaid
New member
1 0 0 0
Message 1 of 2
89
Flag Post

bootup

HP Recommended
hp 17by1071cl
Microsoft Windows 10 (64-bit)

hello .. I been trying to fix this problem for 3 months now off and on ... the  Optane drive must have crashed after the last windows update and now can no logger bootup .. how can I bypass the drv and just use the SSD 

1 REPLY 1
praveenbv
HP Support Agent
HP Support Agent
6,977 6,975 302 367
Message 2 of 2
Flag Post
HP Recommended

 Hi@RudRai, Welcome to the HP Support Community!

 

As I understand you need a fix for the optane drive is crashing,

Don't worry as I'll be glad to help, however, to provide an accurate resolution, I need a few more details: 

Do you get any blue screen errors before the device shuts down?

 

While you respond to that, here's what you need to know:

This scenario usually indicates a problem with the hardware. To help isolate the problem, check the following items:

  1. Overclocking: Disable overclocking to see whether the issue occurs when the system is run at the correct speed.
  2. Check the memory: Verify the memory by using a memory checker. Verify that
  3. at each memory chip is the same speed and that it is configured correctly in the system.
  4. Power supply: Make sure that the power supply has enough wattage to appropriately handle the installed devices. If you added memory, installed a newer processor, installed additional drives, or added external devices, such devices can require more energy than the current power supply can provide consistently.
  5. Overheating: Check whether the system is overheating by examining the internal temperature of the hardware.
  6. Defaults: Reset the system back to the system defaults to see whether the issues occur when the system is running in its default configuration. 

 

If you see that the computer generates a Stop error that contains a BugcheckCode value that is not reported in an event ID 41, change the restart behavior for the computer. To do this, follow these steps:

  1. Right-click My Computer, and then click Properties.
  2. Click Advanced system settings.
  3. Click the Advanced tab.
  4. In the Startup and Recovery section, click Settings.
  5. Click to clear the Automatically restart check box.

If you've been using the Recovery Partition (F11) to reinstall the OS, I recommend using the Recovery media instead to wipe out the HDD and create a new partition and fresh OS installation: Click here to obtain one, if you don't have on in your possession.

 

Hope this helps! Keep me posted.  

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation