cancel
Showing results for 
Search instead for 
Did you mean: 
Sivajith
Level 2
17 10 0 2
Message 1 of 1
81
Flag Post

HP Z Book Studio G3, 1TB M.2 NVMe Installation

HP Recommended
HP Z Book Studio G3
Microsoft Windows 10 (64-bit)

Hello, My Latptop was running with a 256 GB M.2 SED SanDisk M.2 SATA wich is having OS installed on it, and another 1 TB, Intel M.2 SATA SSD which i brought 3 years back and was working fine. Last week my 1TB. Intel drive was showing some issues, then Intel support told me to ugrade the firmware, i did that and that works for a day then the SSD died completely. Now i replaced that drive with a 1TB ADATA M.2 2280 NVEMe, PCIe Gen 3x4 SSD. I connected as the secondary drive as my OS was on 256 Sandisk, it was well, then i swap the drives, and started installing the OS on the new 1TB,NVMe drive, it went fine. After that i installed all the softwares, then i did a reboot then the system stucks on the BIOS menu itself. I tried to swap the drive slots but still the same. When i remove the NVMe drive it works fine, but when ever i connect that the system hangs and stucks. Any advise please, as its a brand new and it work well when i connect first 2-3 times of reboot i dont think it went faulty. Please help.

Only change i made, after the OS installation in the new NVMe drive, i enabled the fast boot and lagecy disabled and secure boot enabled in the bios, after that this issue happened. Then after even i reset my BIOS to factory, still no success.

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation