cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Common problems for Battery
We would like to share some of the most frequently asked questions about: Battery Reports, Hold a charge, Test and Calibrating Battery . Check out this link: Is your notebook plugged in and not charging?
CIOANGEL
Level 1
10 4 0 0
Message 1 of 4
135
Flag Post

OMEN by HP 17-cb0xxx : USB will not properly recognize 512gb Supersonic Rage Elite thumbdrive.

HP Recommended
Omen by HP 17-cb0xxx
Microsoft Windows 10 (64-bit)

HP Omen 17-cb0xxx Laptop sees 512gb usb, but shows no files while saying 70gb on disk. Trying to transfer files from old 2014 hp laptop. it sees usb fine. McAfee sees usb fine on new system and scanned files. File manager sees no files. Also: Would like OS installation Media. My computer came with pre-Chinese hacked OS. Same hack used in nov 2017.

3 REPLIES 3
CIOANGEL
Author
Level 1
10 4 0 0
Message 2 of 4
Flag Post
HP Recommended

I guess it might be a 17t-cb000 CTO according to drivers/firmware page. It looks like I'm going to have to use my support package, since no one is responding.

Was this reply helpful? Yes No
CIOANGEL
Author
Level 1
10 4 0 0
Message 3 of 4
Flag Post
HP Recommended

OK. It's not just a thumb drive, it's ALL thumb drives, AND the m.2 !Tb SSHD as well. This is really messed up.

Was this reply helpful? Yes No
praveen196
HP Support Agent
HP Support Agent
10,488 10,464 477 794
Message 4 of 4
Flag Post
HP Recommended

@CIOANGEL

 

I understand your concerns.

 

Please perform the USB test and check.

 

1. Power off the PC and make sure that it is completely powered off.

2. Press the power button and the moment you press the power button immediately start tapping F2 key, you should see the system diagnostics screen.

3. Look for the component test, under that all the hardware will be listed, please choose USB and initiate the quick test.

Note: If it fails it will generate a 24 digits alphanumeric failure id, please capture that.

 

Have a nice day!!

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation