cancel
tammieh Student
Student
1 0 0 0
Message 1 of 2
142
Flag Post
HP Recommended

ac power cord will only charge when its only plugged in less than halfway

Example: hp notebook g72 serir
Microsoft Windows 10 (64-bit)

i have a hp g72 series computer that will only charge while the computeris on is if i only plug the power cord in less than halfway any ideas how to correct this issue

1 REPLY 1
Distinguished Professor
Distinguished Professor
3,741 3,445 175 526
Message 2 of 2
129
Flag Post
HP Recommended

ac power cord will only charge when its only plugged in less than halfway

Hi!, @tammieh:

 

Welcome, to Forum !.

 

Requirements for all countries or regions:

The requirements, listed below, are applicable, to all countries or, regions:

● The length  of the power cord set  must be at least 1.5m.  (5.0  ft)  and  no more, than 2.0 m (6.5 ft).

● All power cord sets must be approved  by an acceptable accredited agency  responsible for evaluation in the  country or region where the power cord set will be used.

● The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage rating of 125 or  250 V AC, as required  by  each country or  region’s power system.

● The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13  connector for mating with the appliance inlet on the back of the computer.

Kind Regards !.
Have a nice day !.
@Maké (Technical Advisor Premium - HP Program Top Contributor).
Provost in HP Spanish Public Forum ... https://h30467.www3.hp.com/
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation