cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
  • ×
    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
Highlighted
New member
1 0 0 0
Message 1 of 2
103
Flag Post

weak wifi signal only 7%

HP Recommended
15-ay5443TU
Microsoft Windows 10 (64-bit)

My HP Laptop wifi signal strength  is showing only 7% even though only once device is connected to my router which is 450 mbps tplink and interbet service provider is ACTFibernet 50mbps speed.  wifi bars showing only 1 point.

1 REPLY 1
Highlighted
HP Support Agent
HP Support Agent
28,630 28,583 2,359 3,576
Message 2 of 2
Flag Post
HP Recommended

@weak-wifi-signa Here's a related post that should help your cause: Click here to view

If that doesn't help or the issue persists after you've exhausted all the suggested steps, try the below:

 

Reset the TCP/IP Stack and Autotuning 

  1. Restart the computer,
  2. Press the windows button for Start Menu,
  3. In the search box you have opened type “Command Prompt”.
  4. Click (right click) on the search result and select from the menu “Run as administrator”
  5. In the “Command Prompt” window you opened, type “NETSH INT IP RESET C:RESTLOG.TXT”
  6. Press “Enter” on your keyboard.
  7. In the “Command Prompt” window, type “NETSH INT TCP SET HEURISTICS DISABLED”
  8. Press “Enter” on your keyboard.
  9. In the “Command Prompt” window, type “NETSH INT TCP SET GLOBAL AUTOTUNINGLEVEL=DISABLED”
  10. Press “Enter” on your keyboard.
  11. In the “Command Prompt” window, type “NETSH INT TCP SET GLOBAL RSS=ENABLED”
  12. Press “Enter” on your keyboard.
  13. Try rebooting the PC and see if you can pick up the wifi.

Prevent Wi-Fi adapter from turning off while idle

  1. Press and hold the “Windows” button + the “W” button.
  2. Type “Network and sharing center “ in the search box
  3. Press “Enter” on the keyboard.
  4. Click on your Wifi network
  5. The “wifi status” windows should now open.
  6. Click (left click) on properties button in the lower left of the “WiFi status/ Change settings of this connection” option.
  7. In the new windows that opened lets click(left click) on “Configure” button.
  8. Let’s go to “Power Management” tab in the upper side of the window and verify if the option “Allow the computer to turn off this device to save power” is unchecked. If it isn’t, then uncheck it.
  9. Click (left click) on “OK” button in the lower side of the window.
  10. Reboot the PC.

P.S: Welcome to HP Community 😉

 

Let me know how that pans out,

If you feel I was helpful, simply click on Accept as Solution to help the community grow,

That said, I will have someone follow-up on this to ensure you've been helped,

Just in case you don't get back to us, 

have a good day, ahead.

Riddle_Decipher
I am an HP Employee

Reply
0 Kudos
Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation