cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
CarlaMTU
New member
1 0 0 0
Message 1 of 1
4,077
Flag Post

Daisy Chain Settings for Z24nq Monitors - User Guide Incorrect

HP Recommended
Z24nq Monitor
Microsoft Windows 7 (64-bit)

I have two Z 24nq monitors connected to my laptop docking station.  This morning I put my laptop in the docking station, and it will only recognize one external monitor. I cannot get the second monitor to pick up the signal no matter what display options I choose.  

 

A few months ago I chanced on the correct settings to daisy chain through the DisplayPort.  Unfortunately, I didn't write them down.  I say "chanced" because the User Manual posted online does not display instructions that match the On Screen Display (OSD) for my monitors. 

 

The Management option contains DDC/CI Support and Factory Reset only. The DislayPort settings are under the Input Control selection at the top level of the OSD.

 

Z24nq 23.8  (2 monitors - same settings/fw version)

FW Rev AIMM01

2560 x 1440 60Hz

 

Laptop:

HP ZBook 14 (1st Gen)

Windows 7 Pro 64 bit

 

  1. The User Guide needs to be corrected to include what I'm seeing (different firmware causing different menu options?) -- OR, is there a FW update that I should install for my monitors?
  2. Need the correct settings for monitors 1 & 2 DisplayPort daisy-chain settings to extend displays (not mirror). 

 

0 Kudos
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation