I have an error code 0X61011bed

[Madmax1997]

I change the cartridge with HP product but i have an error code )x611011bed. I did what it needs to be done for improper shut down: turn off and turn on the printer not resolved

unplug the printer for 60 sec min, no resolution

reinstalled the cartridge: no resolution

what esle can I do?

Product: HP office jet 6700

[Sneha_01]

Hi @Madmax1997

Welcome to the HP Support Community

I understand you are getting an error message  on your printer. Not to worry I will help you to get a resolution to resolve the issue.

Let's perform a power drain: 

• With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.
• Remove USB cable, if present.
• Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.
• Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.
• Turn on the printer and wait till warm-up period finishes and the printer is idle

Update the printer firmware 

Click here to download and install the latest printer firmware from your product

Click here to know different methods of updating printer firmware.

Hope this helps! Keep me posted for further assistance.

Take care and have a good day.

Please mark this post as “Accepted Solution” if the issue is resolved and if you feel this reply was helpful click “Yes”.

Rachel571

HP Support