cancel
Showing results for 
Search instead for 
Did you mean: 
New member
1 0 0 0
Message 1 of 2
46
Flag Post

Office jet Pro 9010

HP Recommended
Go officejet Pro 9010
Microsoft Windows 10 (64-bit)

Hi, just setting up the all in one printer wirelessly and need to insert the cartridges. However the print head is situated extreme right and not centred. How do I correct its position to enable insertion. Printer is switched on and connected to my laptop.

1 REPLY 1
HP Support Agent
HP Support Agent
16,895 16,875 1,327 1,335
Message 2 of 2
Flag Post
HP Recommended

@Gilera, Welcome to HP Support Community!

 

Follow the steps below to isolate and resolve the issue-

 

Step 1: Check for obstructions in the carriage path

Make sure the carriage path is not blocked.

  1. With the printer on, disconnect the power cord from the rear of the printer.

  2. If your printer has a battery, remove the battery.

  3. Open the door to access the carriage inside of the printer.

    Examples of carriage access doors

    Opening an access door on top of the printerOpening an access door on the front of the printer

  4. Look in the carriage path for debris such as crumpled paper or dislodged labels, and then remove any that you find.

    Example of a printer with debris in the carriage path

    View inside a printer showing crumpled paper in the carriage path causing a carriage jam

  5. If the carriage on your printer has a latch, make sure it is closed.

       CAUTION: 

    Ink tank printers: If the latch is closed, do not press down on it.

     

    If the printhead latch is closed, do not press down on it

  6. Use your hand to move the carriage to each side, making sure it moves freely. If the carriage is stalled or docked to one side of the printer and you cannot move it, continue with these steps.

  7. Close the carriage access door.

  8. Reconnect the power cord to the rear of the printer, and then turn the printer on.

If the error persists, continue to the next step.

 

Step 2: Reset the printer

An error might continue to display after the jam is cleared. To clear the error state, reset the printer, connecting the power cord directly to a wall outlet to make sure the power source is stable and prevent more carriage jams.

  1. With the printer turned on, disconnect the power cord from the printer.

  2. Unplug the power cord from the power source.

  3. Wait 60 seconds.

  4. Reconnect the power cord to a wall outlet and to the printer.

    NOTE: 

    HP recommends plugging the printer directly into a wall outlet.

If the error persists, continue to the next step.

 

Step 3: Service the printer

Service or replace your HP product if the issue persists after completing all the preceding steps.

Go to Contact HP Customer Support to schedule a product repair or replacement. If you are in Asia Pacific, you will be directed to a local service center in your area.

To confirm your warranty status, go to HP Product Warranty Check. Repair fees might apply for out-of-warranty products.

 

Hope this helps! Keep me posted. 

 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

TEJ1602
I am an HP Employee

Reply
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation