01-27-2022 02:53 AM
I have a mechanical problem with the automatic feeder. I lifted the feeder for cleaning but could not lower it back as this encountered resistance and I am worried of breaking it if forced. Anything I can do?
01-29-2022 05:53 PM
The ADF on this model pivots on two hinges. There should not be any resistance. The ADF hinges are just basic pivot points. If you are raising the ADF/scanner assembly together, lowering it may have a small resistance. Check the ADF hinges.
I am a forum volunteer. I do not represent HP.
Didn't find what you were looking for? Ask the community