Create an account on the HP Community to personalize your profile and ask a question
12-27-2020 03:44 AM
Error message paper jam etc. There is no paper in the machine anywhere. It is clean and I have tried all the suggestions to fix to no avail. It goes through the motions and a couple of clunks at the end tell me it won't work and thats it. Everything moves around rollers, etc. My next step is to throw it in the lake and buy another brand. It is four years old circa. I won't of course throw it in the lake as not v eco friendly.
If only you could talk to someone to help fix. Back up support is non existent.
01-01-2021 11:05 AM
I had a similar issue with my old HP Photosmart inkjet printer C8180. There was no paper jam and the paper mostly partially fed and stopped.
I kept removing the rear access door and checking, removing part fed paper only to get the same problem the next time.
I then noticed the long shaft behind the access door that goes across the printer, it's about 6mm or 1/4" diameter, and on the left it engages with a plastic drive cog. But it might not actually be fully engaged, because what seemed to me to be an excessive amount of spline on the last bit of the shaft was showing from the cog; although it looked fully engaged. This cog connects with another driving cog that rotates the shaft. This shaft carries the four rubber rollers that help feed the paper from the tray. You may have a similar design in your printer; if so take hold of the shaft between thumb and forefinger and slide it towards the cog to make sure it is fully engaged. It needs very little effort. My shaft merely engages in the centre of the cog and is not permanently secured, not that clever really! Problem sorted for me, try it with all the roller feeder shafts you can access it might work for you, good luck.
01-02-2021 03:24 AM
Thanks and appreciate your efforts to resolve,
I think mine is similar if I have it correct from what you say. There are 2 cogs on the left of this shaft and they appear to be engaged. On the right, the shaft sort of rests without making a firm engagement so there is quite a bit of give here. I have since tried everything to see if I can solve this but not sure at all as it may not be that which is the problem. It is frustrating as if you could phone HP I am sure it would be resolvable quickly. But there is no one to talk to other than the useless virtual robots. Very bad service from them.
Meanwhile I have ordered a new printer as I am stuffed at the moment without one.
Again thanks for your help but no luck I am afraid.
Didn't find what you were looking for? Ask the community