paper keep Jamming in my HP 2755e

[Tim120863]

paper keep Jamming in my HP 2755e This is a printer just out of the box. The paper goes down 1/2 war and the jams.

[Elohi_NR]

Hi @Tim120863,

Welcome to the HP Support Community. 

I'd like to help!

Perform the following tasks in the order given. Use the printer after each task to see if the issue is resolved.

Clear jammed paper from underneath the printer

Remove jammed paper from underneath the printer.

Press the Cancel button on the printer to automatically clear the paper jam.

If the error persists, continue with these steps.

Press the power button to turn off the printer, and then disconnect the power cord and any other cables from the rear of the printer.

WARNING:

To avoid risk of injuries or electric shock, you must disconnect the power cord before reaching inside the printer.

Lower the paper input tray back into the printer, close the output tray extender, and then push the output paper tray into the printer.

Turn the printer to access the underside (base).

CAUTION:

Before turning the printer, hold the scanner lid and the paper input tray closed with your hands.

Pull the tabs on either side of the cleanout door to open it.

Remove any jammed paper found inside the printer.

Use a flashlight to check for and remove any torn pieces of jammed paper inside the cleanout area.

Gently close the cleanout door by pushing the door towards the printer until both the latches snap into place.

Turn the printer over to its normal position.

Reconnect the power cord and any other cables, and then turn on the printer.

Click here for the remaining steps and see how it goes.

Hope this helps! Keep me posted for further assistance.
Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

[Elohi_NR]

Hi @Tim120863,

Hope I was able to fix the issue. If you need further assistance, feel free to reach out to us. 

Give us some reinforcement by clicking the Accepted Solution button, that'll help us and others see that we've got the answers and did reply to you!

[Elohi_NR]

Hi @Tim120863,

As we did not hear from you, I'll be closing this case for now. If you need further assistance, feel free to reach out to us.