I understand that you are getting No SETUP ink cartridges message.
Please perform the below steps and check.
Step 1: Check the ink cartridges
When you set up your printer for the first time, you must install the SETUP ink cartridges that came with the printer. Open the door to access the ink cartridges, and then make sure the ink cartridges are labeled SETUP.
Turn on the printer.
Open the door to access the ink cartridges.
Wait until the carriage is idle and silent before you continue.
Push in on the front of an ink cartridge to remove it.
Make sure the ink cartridge is labeled SETUP.
Insert the ink cartridge into its color-coded slot until it snaps into place.
Repeat these steps to remove, inspect, and reinsert the remaining ink cartridges.
Close the ink cartridge access door.
If your new printer did not come with SETUP ink cartridges, do not continue with the steps in this document. Return the printer to the retailer.
If the ink cartridges that came with your new printer are labeled SETUP, continue to the next step.
If your printer was working fine, and you installed new ink cartridges, continue to the next step.
Step 2: Reset the printer
Reset the printer to recover from printer failures.
With the printer turned on, disconnect the power cord from the printer.
Unplug the power cord from the power source.
Wait 60 seconds.
Reconnect the power cord to a wall outlet and to the printer.
HP recommends plugging the printer directly into a wall outlet.
Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".