After FIOS was installed, my HP deskjet 3700 began printing some things in huge fonts

[donto]

The problem arose after we switched to FIOS wireless.  Diagnostic sheet says printer is connected to the wireless network FIOS and signal strength is exellent.  The next paragraph says This printer is not connected to the internet.  VERY frustrating--and when downloading some sheet music today, the font was enormous.  Clearly this is a network issue, but how do I solve it?

[Mans]

@donto 

Hello,

Then try to install it over Wi-Fi by doing the following:

Press a series of buttons on the printer to reset the wireless settings to ensure a successful connection.

1. Go to Devices and Printer to delete your printer icon.
2. Make sure the printer is on.
3. If the wireless indicator light is flashing, go to the next step to continue the software installation.
4. Press and hold down the Power button ().
5. While holding down the power button, press the Start Black Copy button () two times, and then press the Cancel button () three times.
6. Release the power button. The Wireless light next to the Wireless button should be flashing. Repeat these steps if the Wireless indicator does not blink.
7. Proceed immediately to the next step to continue the software installation. You have approximately 20 minutes to complete the software setup using the HP Auto Wireless Connect feature.
8. Launch the printer software installed on the desktop and click Connect a new printer.
9. Follow these steps to set up your wireless connection when the HP Automatic Wireless Connection screen appears:
   • Select Yes, send my wireless settings to the printer, and then click Next.
   • Follow the on-screen instructions to complete the software installation and wireless network setup for the printer.

I remain at your disposal in case of need.

Best regards,