MFPM283FDW very noisy start up and print cycles

[Brucens]

MFPM283FDW is very noisy during start up . When printing the same very noisy  level is heard. The printer has done this since installation. The printer is month and a half into warranty. No error messages.

[Jay_G24]

Hi @Brucens,

I'd like to help!

Try the below suggestions -

Let's try a power reset on the printer

Reset the product

• With the printer turned on, disconnect the power cord from the rear of the printer.
• Unplug the power cord from the wall outlet.
• Wait at least 60 seconds.
• Plug the power cord back into the wall outlet.
• Reconnect the power cord to the printer.
• Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

Try updating the printer's firmware - HP Printers - Updating or Upgrading Printer Firmware

Also, check if there is any broken parts or jams inside the printer Paper Jam Error

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping

[Brucens]

Tried this. Have seen the Microsoft solution elsewhere. The printer makes the whining noise each time it is turned on , during printing and  initialising as well .  Thanks for your input

[Jay_G24]

We have tried all the troubleshooting steps from our end, I think this issue needs some additional technical assistance that can be better provided through one-on-one interaction or a remote session with our HP Support team.

Please reach out to HP Support in your region for further assistance.

Hope this helps!

Keep me posted!