cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
rajsri800
New member
2 0 0 0
Message 1 of 2
2,012
Flag Post

08:11 T610 UP PLOTTER PROBLEM

HP Recommended
HP DESIGN JET T610
Microsoft Windows 7 (64-bit)
08:11 display 0% stuck and not take mechine
0 Kudos
1 REPLY 1
davidzuts
Level 13
7,130 7,121 558 1,025
Message 2 of 2
Flag Post
HP Recommended

System Error: 08:YZ (T1100/T1100ps/T610 ONLY)
Problem Description:No comunication between the Front Panel and the Main PCA.Corrective Action:Try the following:1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.2Check that the Front Panel interface cable is not damaged and is correctly connected between the Main PCA and the Front Panel.3Check that the connections between the Formatter and the Main PCA are not damaged and are correctly connected.4If the System Error continues, replace the Formatter. See Formatter on page 6-204.5If the System Error continues, replace the Main PCA. 

 

First thing I would do is remove the formatter with the power off and then reseat it back in the printer and turn the power back on.

0 Kudos
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation