Ask questions. Help others.
The HP Community is here for you.
Post new question
Question
Reply
 
Note on archived topics.
This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here, or click on "Post new question" above and select the appropriate board.
Highlighted
Student
Posts: 1
Member Since: ‎01-03-2013
Message 1 of 2 (593 Views)

DesignJet 4000PS 79-04 - Only when network cable is plugged in

Hey all, Thanks for helping in advance.

 

I have 3 of these plotters in my building and I have just upgraded to the latest firmware to try to resolve witout any luck. It started where we would lose the static settings and they would revert to DHCP. Well, I disabled that scope on the server so they are keeping their IP now.  Now if I boot them up with the network cable plugged in I will get the 79-04 error. If I leave the cable unplugged it will boot just fine but the minute I plug it in, it will error. This is happe ning to all 3 machines... I have cleared the printers off the print server and recreated without any luck as well. Any help would be greatly appreciated. Thanks!

 

 

0 Kudos
Master's Graduate
Posts: 475
Member Since: ‎08-11-2010
Message 2 of 2 (589 Views)

Re: DesignJet 4000PS 79-04 - Only when network cable is plugged in

I have had similar problems with a Z3200 in regards to the printer looking for communication from the server via DHCP and not getting it due to the server changing the port it communicated through. I hooked up a laptop to the printer via a crossover cable and it worked just fine. The problem was a server issue. I am not sure how you have your server setup for printers, but if you can connect via a laptop or desktop computer and can ping that IP address then you have an issue with how your server is communicating with it.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation