Ask questions. Help others.
The HP Community is here for you.
Post new question
Question
Reply
 
Note on archived topics.
This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here, or click on "Post new question" above and select the appropriate board.
Honor Student
Posts: 2
Member Since: ‎01-21-2014
Message 1 of 2 (405 Views)

HP 3005dn does not initialize - possible firmware problem

Good day all,

 

I have a printer HP 3005dn that does not initialize.

I have tried a firmware upgrade and it gave me an error at 1/6 phase . If it does not go forward then 1/6 then it does not initialize and it will not say READY . This is my main problem, I cannot get to READY .

 

When I start the printer I get:

RFU LOAD  ERROR  1/6  SEND FRU UPGRADE

after a few seconds it says

Download file new 1/6 SEND RFU UPGRADE

 

I would like to know if I can reset the software or rewrite or if I can update taking in consideration that the formatter has 2 USB . Can't I put the software on the stick and plug it into USB to perform the update via USB stick ?

 

Thank you very much for your time

I wish you all a good day

0 Kudos
Highlighted
Honor Student
Posts: 2
Member Since: ‎01-21-2014
Message 2 of 2 (365 Views)

Re: HP 3005dn does not initialize - possible firmware problem

So hard to find an answer for this one.  Smiley Sad

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation