Ask questions. Help others.
The HP Community is here for you.
Post new question
Note on archived topics.
This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here, or click on "Post new question" above and select the appropriate board.
Honor Student
Posts: 2
Member Since: ‎08-11-2014
Message 1 of 5 (555 Views)

HP T120



does anyone know if my HP T120 can connect to a WPA2 Wi-Fi nework, please? I don't even see my network name in the selection during the setup procedure. 


Thanks Jakub

0 Kudos
Posts: 2,277
Member Since: ‎04-12-2012
Message 2 of 5 (535 Views)

Re: HP T120



WPA2 is a certification protocol, not related on how the router broadcast or how it can be discovered by nearby hosts.


If the printer cannot find the router, here are posible causes:


1- The printer is out of the range of the router. Try moving the printer closer

2- The router connection is hidden

3- The wireless card on the printer might have problems


Best regards


Mike G

Best regards

Mike G

I'm an HP Inc employee. But my response is not in behalf of HP Inc
Posts: 1
Member Since: ‎08-20-2014
Message 3 of 5 (495 Views)

Re: HP T120

I have the same problem, the T120 printer does not recognize my Wifi network with WPA password protected, and the wifi networks from neighbors she acknowledges.

I put it next to the router, and all the room computadors recognize the Wifi.

What the problem is?
Honor Student
Posts: 4
Member Since: ‎08-26-2014
Message 4 of 5 (445 Views)

Re: HP T120



Make sure the network cable is not connected to printer while trying to connect Printer to wireless as it supports either wired or wireless.... Make sure the blue light is lit and print wireless network test from settings to check for any issues...

try reset network settings connectivity>Restore network Defaults.


Hope this helps.



Top Student
Posts: 5
Member Since: ‎10-01-2011
Message 5 of 5 (439 Views)

Re: HP T120

I just set mine up on Saturday, The setout software didn't automatically see the printer but windows explorer did.

Right clk the printer icon and cut & paste the network address into the sotware where it says to do it manually.

Hey presto magico!


† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation