HP error codes

[Mopic]

The printer will not power up. When I reboot I get a different error code each time Some starting with ox others stating load tray Any Idea on how to fix?

[A4Apollo]

Hi! @Mopic, Thanks for stopping by HP forums!

I understand when you reboot your printer you are getting an error on your printer.

Don't worry I'll try to help you out.

Did you make any changes to your printer?

Please try the steps recommended below.

In some cases, removing the ink cartridges and resetting the printer can clear the error message.
Turn on the printer.
Wait until the printer is idle and silent before you continue.
Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
Remove the ink cartridges from the printer.
With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
Wait at least 60 seconds.
Plug the power cord back into the wall outlet.
   NOTE:
HP recommends connecting the printer power cord directly to a wall outlet.
Reconnect the power cord to the rear of the printer.
Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
Reinsert the ink cartridges, and then close the ink cartridge access door.
If you receive a prompt to print a calibration page, do so.
If you disconnected the USB cable, reconnect it to the rear of the printer.
Try to print.

Refer this article to further troubleshoot '0xc19a0005' Error or Similar Error Display on the printer.

Take care,            

Have a great day ahead! 🙂