Ask questions. Help others.
The HP Community is here for you.
Post new question
Note on archived topics.
This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here, or click on "Post new question" above and select the appropriate board.
Posts: 1
Member Since: ‎11-21-2008
Message 1 of 4 (12,714 Views)

LaserJet 3055 Scan issue?

I have installed and connected a LaserJet 3055 All-in-one to my company network.  Can this device Scan to E-mail?  I cannot find any configuration settings to allow this, it will only scan to a PC.  There is not PC connected directly to this device and my boss insists that it can be done.  Any help or just a flat out "no it can't" would be greatly appreciated.



0 Kudos
Top Student
Posts: 5
Member Since: ‎11-29-2008
Message 2 of 4 (12,589 Views)

Re: LaserJet 3055 Scan issue?

Are you talking about from the PC or the printer itself

From the PC you can select from the Set up after you select Scan from the ToolBox

Posts: 102
Member Since: ‎04-08-2010
Message 3 of 4 (10,951 Views)

Re: LaserJet 3055 Scan issue?


When you open the LJ3055 scan application there is a "settings" button on the lower left side of the window that allows you to set up a scan to location and then send the scan to destination to the device Control Panel.  This will give you the scan to destination on the LJ3055's Control Panel.  In order to have Scan To to work from the LJ3055, the PC with the software installed needs to be on- and Toolbox needs to be running.  If either one of these is off, a "cannot connect" error will be seen on the LJ3055 Control Panel.

Although I am an HP employee, I am speaking for myself and not for HP.
Posts: 1
Member Since: ‎09-08-2011
Message 4 of 4 (7,642 Views)

Re: LaserJet 3055 Scan issue?

Dissconnect Printer form PC or Laptop

''Power off" printer > Press & hold 'ENTER' > 'Power on'. Continue to hold 'ENTER' key only till "Program storage intt." (or similar nsg.) appears.
Wait & Let the unit boot to "Ready" message in the screen. Reload PC with device driver. Try to scan. If error persists Formatter PCB may need replacement.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation