cancel
Showing results for 
Search instead for 
Did you mean: 

Note on archived topics.

This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here and select the appropriate board.
HouserBuilders
New member
1 0 0 0
Message 1 of 2
1,870
Flag Post
HP Recommended

Officejet 6210 Al-In-One Error Code

Unit has all lights flashing. Error:0xc0620004411:lib-micci2.c
0 Kudos
1 REPLY 1
mujju
Level 2
22 22 0 9
Message 2 of 2
1,840
Flag Post
HP Recommended

Officejet 6210 Al-In-One Error Code

Hi 

 

Try the following steps:

 

Make sure unit is plug directly into a wall outlet and not connected to any power strips or surge suppressors

 

Note : Power strips and surge suppressors can sometimes prevent enough voltage from reaching the product.


1 . Without turning off the product, disconnect the USB cable from the rear of the product.
 2. Remove the cartridges from the product.
3.  Wait for the ' Insert Cartridges ' message to display on the control panel.
4.  Disconnect the power cord from the back of the product.
5.  Wait 60 seconds.
6.  Reconnect the power cord. If the product does not automatically turn on, press the Power button.
7.  Reinsert the cartridges, and then close any open doors on the product.
8.  If you receive a prompt to print a calibration page, do so.
9.  Reconnect the USB cable to the rear of the product, and then try printing again.

Hope this should help

0 Kudos

Note on archived topics.

This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation