cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
stilty
New member
4 2 0 0
Message 1 of 2
221
Flag Post

Replacing Plastic piece in front of Main Input Tray

HP Recommended
laserjet 1320
Microsoft Windows 10 (64-bit)

OOPS

While refilling paper, I dropped the main input tray, and the plastic piece in front fell off and i cant get it back on.  The printer prints fine(it was just sitting there while this happened) except that i cant pull the tray out of the printer if the plastic piece is not there.

 

It is the dark gray piece with the number 2 on the lower right.

 

Would anyone out there know how to put the plastic piece back into the tray?

 

thx

md

0 Kudos
1 REPLY 1
SHThompson
Level 12
3,729 3,679 305 669
Message 2 of 2
Flag Post
HP Recommended
I sold my spare tray on eBay a while back so I can't look at it to see how to do what you want but on the other hand I see the tray on eBay for as low as $20 shipping included.

If my post resolves your issue please click the accepted as solution button under it.


To thank a Tech for a post click the thumbs up button under the post.


You can even click both buttons. . .
0 Kudos
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation