The HP Community is here for you.
12-12-2010 10:42 AM
I receive this message when I try the wireless install:
Your computer is unable to communicate with your printer at 192.168.2.2. (IP Address) This may be caused by firewall software. If you are using firewall software, verify that UDP port 427 is unblocked for both inbound and outbound traffic.
Your PC can not communicate with your printer at address 192.168.2.2 (IP Address). Check all cable connections. Check that the printer, PC and router are powered on and connected to the network.
I am running win xp (sp3) with a belkin wireless router. No av/firewall installed. The printer installs without any problems via usb. I ran a diagnostic report which hasn't found any problems:
Wireless On: PASS
Wireless Working: PASS
SSID found: PASS
Printer settings consistent with router settings: PASS
No Filtering: PASS
Signal strength: Good
Other networks detected matching your ssid: No
Wireless networks detected: 6
Downlink count: 133
Network name: belkin
Hardware address: 1c:c1:de:3b:cf:72
IP Address: 192.168.2.2
Config source: DHCP
Comm Mode: Infrastructure
Auth type: WPA-PSK
I would be grateful if someone could point me in the right direction, I sure it's something simple but I have no idea where to start.