• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎12-11-2020 12:55 AM

HP Recommended
Product: HP Color LaserJet MFP M776

Good afternoon.

The problem was web access to the printer. This opportunity fell off, and then scanning over the network.
There was a reset to factory settings, replacement of physically network wires and other vlan - did not help.
HP support advised to reflash the device. There is only one firmware on the site (cljM776_fs4.11.0.3_fw_2411117_061344.zip). Firmware through USB led to the fact that the device was not initialized during boot and constantly fell into error 81.09.00

I was looking for a solution here and did not find it.
Only the topic where they tried to physically change the "faulty" (most likely it was working) MFP formatter. Result: MFP went to the trash can. It's funny ☺ (81.09.00 error MFP 586)

Error 81.09.00 is really connected with the formatter, or rather with JetDirect.


Solution:
When loading the printer - enter the Administrator mode.
Select: Config TPM -> Stop use -> Accept -> Reboot.
The printer will boot and deploy the new firmware without TPM encryption mode.
Next, enter the administrator mode again when loading the printer and turn on the config TPM back. Reboot.


All. The printer is ready.
Good luck to all!
PS Google translator. Excuse me. ☺

Category:
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.