9015e close tray message when tray is closed

[mptova]

9015e close tray message when tray is closed

[Nal_NR]

Hi @mptova,

Welcome to the HP Support Community. 

I'd be happy to help you! 

Try the steps recommended below.

Check for obstructions that prevent the input tray from closing

Remove any paper or other obstructions from underneath the printer and inside the gap where the input tray slides into.

Press the Power button to turn off the printer.

Grasp the handle on the input tray, and then pull the tray toward you to open it.

Figure : Pull to open the paper tray

1. 

Remove any loose sheets of paper from the input tray or any paper that blocks the photo tray.

Remove the output tray, and then set it aside.

Figure : Remove the output tray

1. 

Turn the printer onto its right side so you can access its underside.

Check the gap where the input tray was. Remove any loose paper or other obstructions in the gap. If any paper is jammed inside the gap, grasp the paper with both hands, and then pull the paper slowly but firmly toward you to remove it. Gently remove any jammed paper and bits of torn paper.

Figure : Turn the printer onto its right side, and then remove any obstructions

1. 

   CAUTION:

Remove paper from the gap as carefully as possible. If any torn pieces of paper remain inside the printer, a paper jam is likely to occur, which could damage the print mechanism.

Turn the printer back over to its normal position, and then reinsert the input tray, pushing it into the printer until it locks into place.

Figure : Push in the paper tray

1. 

   NOTE:

The tray clicks into place when it is completely closed, and the printer makes noise.

Grasp the output tray by the sides, and then replace the output tray with the input tray.

Press the Power button to turn on the printer.

Wait until the printer finishes warming up, and then check the control panel to see if the error message has cleared.

Click here for further assistance. 

If the issue still persists after trying out the steps.

It is a hardware issue with your printer.

Please contact HP support for service options.

Hope this helps! Keep me posted for further assistance.

 Please mark this post as “Accepted Solution” if the issue is resolved and if you feel this reply was helpful click “Yes”.