HP6500 printer says it has no paper, but paper is loaded properly

[Greg6229]

Paper is loaded, but printer says it is not

[TEJ1602]

@Greg6229, Welcome to HP Support Community!

I see that the printer gives out of paper error when you try to print, follow the steps below-
 

Check the paper, and then reload it

Check the paper stack for defects such as wrinkled, torn, or bent pieces that might cause a pick-up issue.

1. Remove any paper from the paper tray.

2. Remove any severely bent, wrinkled, or torn paper found in the stack.

3. Check for obstructions inside the paper tray. Make sure nothing blocks the paper from engaging with the rollers.

4. Make sure the paper stack is even on all sides.

5. Load the stack of paper into the paper tray.

   

6. Close or push in the paper tray.

7. Select the correct paper size on the printer control panel or in the printer software

Reset the printer

Reset the printer to recover from printer errors or failures.

1. With the printer turned on, disconnect the power cord from the printer.

2. Unplug the power cord from the power source.

3. Wait 60 seconds.

4. Reconnect the power cord to a wall outlet and to the printer.

   NOTE: 

   HP recommends plugging the printer directly into a wall outlet.

5. Turn on the printer to complete the reset.

Try printing.
 

Hope this helps! Keep me posted. 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!