cancel
Showing results for 
Search instead for 
Did you mean: 
Common problems for INSTANT INK, HP+ PLANS: INK AND TONER
We would like to share some of the most frequently asked questions about Instant Ink. Check out this link: HP INSTANT INK, HP+ PLANS: INK AND TONER. .
Bunny1964
New member
1 0 0 0
Message 1 of 2
92
Flag Post

I put in a new cartridge and it still is telling me I have a "Defective Cartridge"

HP Recommended
HP OfficeJet Pro 8035

I put in a new cartridge and it still is telling me I have a "Defective Cartridge", but it's a new cartridge? I turned off my printer hoping it would reset it, but it didn't... Any suggestions?

1 REPLY 1
sandytechy20
HP Support Agent
HP Support Agent
25,696 25,576 1,412 1,484
Message 2 of 2
Flag Post
HP Recommended

@Bunny1964

 

Welcome to the HP support community.

 

Make sure the cartridges are correctly installed

  1. Turn the printer on.

  2. Open the door to access to the cartridges.

  3. Make sure the label on the cartridge matches the label on the carriage.

    Correctly installed cartridges

  4. Make sure all the cartridges are firmly in place. If a cartridge is sticking out farther than the others, press it down until it snaps into place.

  5. If a cartridge does not stay in place, remove it from its slot, bend the tab away from the cartridge, and then reinsert the cartridge into its slot.

       CAUTION: 

    Do not bend the tab more than 1.27 cm (0.5 in). Moving the tab too far might cause the tab to break off.

    Bending the tab

  6. Close the cartridge access door.

Clean the electrical contacts

  1. Open the door to access to the cartridges.

  2. Wait until the carriage stops moving before you continue.

  3. Push the tab on the cartridge indicated by the error message, and then pull the cartridge from its slot.

       CAUTION: 

    Clean the cartridges one at a time. Do not leave a cartridge outside of the printer for more than 30 minutes.

    Removing a cartridge from the carriage

  4. Wipe the copper-colored contact on the cartridge with a lint-free cloth.

    Copper-colored cartridge contact

  5. Place the cartridge to the side, with the contacts facing upwards.

  6. Wipe the contacts inside the printhead with a lint-free cloth.

    The printhead contacts

  7. Insert the cartridge into its slot, and then press down on the cartridge until it snaps into place.

  8. Repeat these steps for any other cartridges indicated in the error message.

  9. Close the front door and cartridge access door.

You can refer this HP document for more assistance:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation