My D110 makes a horrible clicking sound when I have it print

[YooperRev]

This just started today.  When I choose "Print" the printer makes a horrible clicking sound before printing, as if gears are slipping.  There are no error messages and the machine DOES print, but the sound is frustrating.

[KrazyToad]

@YooperRev

Welcome to HP Support Community

Let's start with a printer reset

(1) Turn the printer on, if it is not already on.
(2) Wait until the printer is idle and silent before you continue.
(3) With the printer turned on, disconnect the power cord from the rear of the printer.
(4) Unplug the power cord from the wall outlet.
(5) Wait at least 60 seconds.
(6) Plug the power cord back into the wall outlet.
 NOTE: HP recommends connecting the printer power cord directly to the wall outlet.
(7) Reconnect the power cord to the rear of the printer.
(8) Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed
 

Then check for Printer Firmware update. You can refer to this Link: https://support.hp.com/in-en/document/c02919168

Also follow the instructions in Solution Four from this Link: https://support.hp.com/in-en/document/c02096940 to clean the Rollers

Keep me posted how it goes and have a great day 😊

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.