cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Know the Benefits of your HP account

    Connect with HP support faster, manage all your devices in one place, view warranty information and more– Click Here

    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
  • ×
    Information
    Know the Benefits of your HP account

    Connect with HP support faster, manage all your devices in one place, view warranty information and more– Click Here

    Information
    Fix Windows 10 Update Issues

    Resolve Windows 10 or update issues on HP computer or printer– Click Here

  • post a message
Highlighted
New member
1 0 0 0
Message 1 of 2
53
Flag Post

Ox6100004a message HP OfficeJet Pro 6950.

HP Recommended

 

 
Ox6100004a message HP OfficeJet Pro 6950.

I am getting repeated error message and asking to unjam paper when there is no jam in place.  The system is telling me to switch off and on again but it will not shut down, I have unplugged it and re started but the same message is coming up

 

1 REPLY 1
Highlighted
HP Support Agent
HP Support Agent
18,169 18,146 1,138 1,142
Message 2 of 2
Flag Post
HP Recommended

@RLT10


Welcome to HP Community

 

I have gone through your Post and would like to help

 

Please try these steps

 

- Turn on the printer.
- Wait until the printer is idle and silent before you continue.
- Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
- Remove the ink cartridges from the printer and clean the electrical contacts with a lint free cloth
- With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
- Wait at least 60 seconds.
- Plug the power cord back into the wall outlet.
NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
- Reconnect the power cord to the rear of the printer.
- Turn on the printer, if it does not automatically turn on.
- The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
- Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
- Reinsert the ink cartridges, and then close the ink cartridge access door.
- If you receive a prompt to print a calibration page, do so.
 

Also ensure the Firmware is updated. Link: https://support.hp.com/in-en/document/c02919168

 

Thank you

 

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.
 

KrazyToad
I Am An HP Employee

Reply
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation