Power, paper, cancel button, and display blink slowly

[Mezmeryzer]

For inject 2622 the printer is not working correctly. All the lights blink slowly and printer is non responsive 

[Jay_G24]

Hi @Mezmeryzer,

I'd like to help!

Try the below suggestions-

Reset the product

• With the printer turned on, disconnect the power cord from the rear of the printer.
• Unplug the power cord from the wall outlet.
• Wait at least 60 seconds.
• Plug the power cord back into the wall outlet.
• Reconnect the power cord to the printer.
• Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

This condition occurs when there is no paper in the input tray. Load the printer with plain white paper.

Figure : The Error icon, the Paper Error icon, and the Resume light are on

1. Raise the input tray.

   

2. Slide the paper width guide all the way to the left.

   

3. Load a stack of plain white paper into the input tray.

   

4. Slide the paper width guide to the right until it rests at the edge of the paper.

   

5. Lower the output tray, and then pull out the tray extender.

   

Refer to - Blinking Lights

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will h