document feeder error mispik

[DrCox]

im trying to use the feeder on my printer for several sheets and it will not pull them through. its saying document feeder Mispik

[Jay_G24]

Hi @DrCox,

Welcome to the HP Support Community

I'd like to help!

I understand you are facing a paper mispick issue.

Try the below suggestions -

Clean the automatic document feeder (ADF)

If your printer has an ADF, clean it regularly to help avoid paper jams and quality problems.

1. Get a lint-free cloth and distilled water.

2. Remove the original document from the ADF.

3. Turn off the printer, and then disconnect the power cord.

4. Open the ADF cover.

   

5. Find the paper pick rollers and the separator pad inside the ADF.

   

   Callout

   Description

   1.

   Paper pick roller

   2.

   Separator pad

6. Lightly dampen a clean, lint-free cloth with filtered or distilled water, and then squeeze any excess liquid from the cloth.

7. Use the damp cloth to clean the paper pick rollers and the separator pad.

8. Leave the ADF cover open for two minutes to allow the rollers and pad to dry.

9. Close the ADF cover.

10. Reconnect the power cord, and then turn on the printer.

Reset the printer

Reset the printer to recover from printer errors or failures.

1. If your printer has a rechargeable battery, remove it.

2. With the printer turned on, disconnect the power cord from the printer.

3. Unplug the power cord from the power source.

4. Wait 60 seconds.

5. Reconnect the power cord to a wall outlet and to the printer.

   NOTE: 

   HP recommends plugging the printer directly into a wall outlet.

6. Turn on the printer to complete the reset.

If the error persists,

• I've sent you a private message with further instructions to get this issue sorted.
• In order to access your private messages, click the private message icon on the upper right corner of your HP community profile, next to your profile Name or simply click on this link:  https://h30434.www3.hp.com/t5/notes/privatenotespage

Hope this helps! Let me know how it goes.

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Yes" on the bottom right to say “Thanks” for helping