cancel
Showing results for 
Search instead for 
Did you mean: 
Common problems for INSTANT INK, HP+ PLANS: INK AND TONER
We would like to share some of the most frequently asked questions about Instant Ink. Check out this link: HP INSTANT INK, HP+ PLANS: INK AND TONER. .
Thersagran-21
New member
1 0 0 0
Message 1 of 2
86
Flag Post

error on printer

HP Recommended
Microsoft Windows 10 (64-bit)

I have no idea why my HP 6000 printer is flashing a 0 then E sign. It will not let me print but have no idea what to do

 

1 REPLY 1
Jay_G24
HP Support Agent
HP Support Agent
14,170 14,137 1,157 1,278
Message 2 of 2
Flag Post
HP Recommended

Hi @Thersagran,

 

I'd like to help!

 

I understand you were facing "E0" error.

 

Try the below suggestions

 

Reset the printer

Reset the printer to recover from printer errors or failures.

  1. If your printer has a rechargeable battery, remove it.

  2. With the printer turned on, disconnect the power cord from the printer.

  3. Unplug the power cord from the power source.

  4. Wait 60 seconds.

  5. Reconnect the power cord to a wall outlet and to the printer.

    NOTE: 

    HP recommends plugging the printer directly into a wall outlet.

  6. Turn on the printer to complete the reset.

Clean the ink cartridge and carriage electrical contacts

Remove any debris or buildup from the contacts on the cartridges and in the carriage.

  1. Open the door or lid to the cartridge access area. Wait until the carriage stops moving before continuing.

  2. Remove the cartridge indicated in the error message from the carriage.

    • Carriages with cartridge latches: Open the latch, and then pull the cartridge up and out of the slot.

      Removing the ink cartridges with latches from the carriage

    • Carriages without cartridge latches: Gently press down on the cartridge to release it, and then pull it out of the slot.

      Removing the ink cartridges from the carriage

  3. Holding the cartridge by the sides, remove any protective tape that still might be on the contacts.

    CAUTION: 

    Do not touch the ink nozzles or the copper-colored electrical strip. Touching or trying to remove these parts can result in clogs, ink failure, and bad electrical connections.

    Removing tape from the ink cartridge

  4. Lightly dampen a lint-free cloth with distilled water, and then wipe the copper-colored contacts on the cartridge.

    Cleaning the ink cartridge contacts

  5. Lightly dampen a lint-free cloth or swab with distilled water, and then clean the electrical contacts in the carriage.

    Cleaning the contacts in the carriage

  6. Wait 10 minutes for the contacts to dry, and then reinsert the cartridge into its color-coded slot.

  7. Repeat these steps for the other cartridge if it was indicated in the error message.

  8. Close the door or lid to the cartridge access area.

    If the error persists, clean the cartridge and carriage contacts a second time.

Try the steps in the document - Blinking Lights and Error Codes

 

Hope this helps! Keep me posted. 

 

And, Welcome to the HP Support Community. 

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation