cancel
Showing results for 
Search instead for 
Did you mean: 
suzflores
New member
1 0 0 0
Message 1 of 3
399
Flag Post

Samsung c410w imaging transfer belt and fuser

HP Recommended
samsung xpress c410w
Microsoft Windows 10 (64-bit)

Awhile ago I replaced the imaging drum - NO PROBLEM.  Well I got a flashing red light now and found out it is time to replace the imaging transfer belt and the fuser.  I followed the instructions and replaced them both, however i still have a red flashing light.  When I run the SnycThru web service, it tells me to replace the transfer belt and fuser.  I did that so now what???   I double checked the new parts with the old and the numbers are the same made sure everything went  back the way it is supposed to.  I printed a page out and it was fine however now the pages are coming out light.  HELP!!!!!   TIA!

2 REPLIES 2
Valsimot
Level 12
Level 12
6,346 6,329 754 1,062
Message 2 of 3
Flag Post
HP Recommended

You need to reset the counter on replaced parts, only authorised service centres have tools ( special software ) that can reset counters.




My profile on LinkedIn

Was this reply helpful? Yes No
KOTO1
New member
1 1 0 0
Message 3 of 3
Flag Post
HP Recommended

I have the same problem.  The original parts are readibly available in the open market, and not difficult to replace.  I went into Techmode and reset the counters, but the Transfer Belt counter has not changed and I still have the red flashing light.   How am I expected to know when the transfer belt will need changing again.

Tags (1)
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation