HP OJ Pro 8710 scannig oversized documents

[WLa1]

wanting to scan a document bigger than A4 I want to remove the cover containing also the ADF system. Analysing the system I feel this should be possible. The manual does not show however any hints.

is this principally possible? And, if yes, how to do so?

[sandytechy20]

@WLa1

Welcome to HP support community.

Below is the maximum scan size supported by the printer.

• Maximum scan size from glass (all models): 216 x 356 mm (8.5 x 14.0 inches)

• Maximum scan size from ADF (all models): 216 x 356 mm (8.5 x 14.0 inches)

You can refer this HP document for more assistance:- Click here

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

[WLa1]

the maximum size for scanning I know - that's not the problem. But take an oversized document - how do you scan this when the cover is standing upright and does not allow you to center your A3 or A2 document on the glas of the scanner?

[WLa1]

to be more precise: I want to scan a part only of a document which is much larger than A4 (210x296mm) and which i cannot cut to the scan size of the scanner. Even folding it is not possible because it is a card bord.

Does this explain my problem? How can I remove the cover of the OJ Pro 8710 Scanner?

[sandytechy20]

@WLa1

I am afraid, you can not scan any document larger than the supported size.

If it is not possible to fold or cut, then there is no option to scan.

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.